The sun, the technique of "sausage", from polymer clay "Fimo".
This technique is suitable for you if you want to produce a large number of similar products.
The procedure is as follows:
1. Make the transition color from yellow and red plastic
2. Roll the layer with a gradient of 3mm
3. Roll out a layer of white plastic with a thickness of approx. 1mm
4. Fold together, roll into a tube
5. From the color remains make layers of different thickness and color (red, orange, yellow, etc.)
6. Intermingle them with layers of different thicknesses of white color
7. The width of the carpicha should be equal to the height of the rolled tubule
8. Mark and cut into 7 equal segments
9. We put the rays
10. In the intervals we put white plastic
11. Turn white plastic around the whole workpiece
12. We pull out sausage, cut, admire
Recycling:
From the remaining layer with a gradient, you can make such unpretentious beads. We roll a layer 1-2mm thick, cut into strips (I have 7-8mm wide), we twist into tubes.
And These are the remnants after working with sausage (her ass, etc.) plus waste from another production with silver and black plastic. Here is a cut stone
What else can you do using the sausage technique.
Comments
When commenting on, remember that the content and tone of your message can hurt the feelings of real people, show respect and tolerance to your interlocutors even if you do not share their opinion, your behavior in the conditions of freedom of expression and anonymity provided by the Internet, changes Not only virtual, but also the real world. All comments are hidden from the index, spam is controlled.