INSTRUMENTS for removing the blocker

It is recommended to a professional to dismantle the blockers to have a tool prepared and "sharpened" for his work. In this section, more about what you might need:

Tool 1 - L-shaped hexagon for 8 mm

You can buy any set of hexagons - they will be enough to work with the blockers. The price of this set ranges from 4 to 30 UAH. You can buy in any tool store or a construction hypermarket.


Tool 2 - shortened L-shaped hexagon on 6 mm

The essence of the preparation of this tool is to refine it by shortening the smaller side. It should be 10-15mm, not more. Otherwise, it will not be possible to get close to the foot bolt that is facing the tire.
Moreover, a cut piece of hexagon can be adjusted to a spring, which will very quickly unscrew the already "torn" bolt.

L-shaped hexagon for 6 mm


Tool 3 - Screwdrivers

In the process of removing the blocker, you may need a slotted screwdriver and a cross screwdriver.


Tool 4 - Pliers

Pliers are used to unscrew the pins that hold the lid of the blocker. The more the lever of pliers - the better. Even better, if it's curved pliers. Then it will be convenient to hook the hub cap.


Scanning (unfolding) Tool 5 - Sweep

Adaptation, which can deploy bolt holes in the red cover, so that the caps of the axle bolts come out. You can use the Soviet triangular file. It will be more convenient, of course, to use a specially prepared tool.

The diameter of the hole in the lid is 13 mm. The diameter of the cap of the bolt is 16 mm, but it needs to be reamed by 17 mm, so that the bolt leaves unhindered. In depth, we have about 20 cm at our disposal. From these data emerges a drawing of the unfolding:

The pen can be done any - at least under a balonnik, even as a screwdriver. It is best to make a spreader from a 19 mm sword. Lightly shape the Bulgarian and deal with the hat.

For non-slim - you can just carry a hand drill with a drill bit 18-19mm :)

Do not neglect this tool! Recently, it is becoming more relevant!


Tool 6 - Slingshot Slotty for the blocker

The most correct and quiet tool. It is a kind of key to which the combination of Suvald in the castle is not important. It simply needs to be inserted in the lock, put a wheel key on it (it is used as a lever), press it slightly and .. the lock is open!

At the moment, various variants of the rolls are being tested to determine the best of them. After that, on the pages of the site will be laid out a draft of the curtail "winner".

Drawing of a roll (wrestler)

Read how to open the lockers