Start of section
Production, amateur Radio amateurs Aircraft model, rocket-model Useful, entertaining |
Stealth Master
Electronics Physics Technologies Inventions |
Secrets of the cosmos
Secrets of the Earth Secrets of the Ocean Tricks Map of section |
|
Use of the site materials is allowed subject to the link (for websites - hyperlinks) |
TECHNOLOGY OF MANUFACTURE OF THE ADHESIVE SOLUTION OF THE FOAM
IN DICHLOROETHANE OR ACETONE
Glossary of terms |
Only | B | In | | G | D | Ж-и | To | | L | M | N | About | N | Rs | T-y | Fc | Ш-я |
Adhesive foam solution in dichloroethane or acetone is resistant to alkali and also alkaline electrolyte can also serve as a protective film for the painted surface. The solution is prepared in a clean glass container, pouring small pieces of polystyrene into the solvent. The solution is forced to own a silicate glue density. On degreased with pure gasoline or acetone, also the dried surface is applied with a brush, the thin layer of the solution is also dried. Then the surface is covered with paint or bituminous lacquer, after which the solution is applied again after drying. As a result, a layer of paint or varnish will be between the double layer of alkali-resistant coating. In this way, it is good to cover, for example, cans of alkaline batteries. The solution is also toxic volatile. To prepare a solution, it is also necessary to work with it in an open atmosphere or in a place with good ventilation. Keep the solution in a container with ground glass stopper.
Comments
When commenting on, remember that the content and tone of your message can hurt the feelings of real people, show respect and tolerance to your interlocutors even if you do not share their opinion, your behavior in the conditions of freedom of expression and anonymity provided by the Internet, changes Not only virtual, but also the real world. All comments are hidden from the index, spam is controlled.