Start of section
Production, amateur Radio amateurs Aircraft model, rocket-model Useful, entertaining |
Stealth Master
Electronics Physics Technologies Inventions |
Secrets of the cosmos
Secrets of the Earth Secrets of the Ocean Tricks Map of section |
|
Use of the site materials is allowed subject to the link (for websites - hyperlinks) |
TECHNOLOGY OF MANUFACTURE OF ADHESIVE FOR SKYING SKIN
Glossary of terms |
Only | B | In | | G | D | Ж-и | To | | L | M | N | About | N | Rs | T-y | Fc | Ш-я |
The skin is glued together with a solution of pure rubber in carbon disulfide . The parts to be glued should be slightly heated and the glue should be rubbed carefully on the premise of the future seam. It is recommended to add a small amount of turpentine to the solution obtained .
Glue for the skin can be prepared as follows : a benign glossy carpentry adhesive is soaked in water for a day and then slowly melted on fire with a small amount of water. Later this is added to the liquid mass of tannin , which makes it look like a sticky thread. The gluing is done by this sticky mass, and the skin must be pre-cleaned (washed with gasoline) and also roughened with glass paper (skins).
Comments
When commenting on, remember that the content and tone of your message can hurt the feelings of real people, show respect and tolerance to your interlocutors even if you do not share their opinion, your behavior in the conditions of freedom of expression and anonymity provided by the Internet, changes Not only virtual, but also the real world. All comments are hidden from the index, spam is controlled.