The current rotation

This current marks left hand. For his performance, take a deck of cards, shuffle it thoroughly, allow to remove the viewer. After removing the upper part of the deck is in the palm of his left hand, and lies horizontally, and the lower part of the deck is held between thumb and forefinger of his right hand. Put the little finger of his left hand on top of the deck in your left hand and place it on top of the deck of the right hand. Then remove the right hand side, and the left hand by taking the second part of the deck, holding both her and half the fingers should be positioned as shown in the photo, below.

Then the left hand operates as follows. The index, middle, ring and pinky fingers, reveal - make the gap a little bit wider, only to wide slot in the resulting walked right thumb. Then, the left thumb pushes inside the gap left edge of the top of the deck, causing it to rotate clockwise, and the index, middle, ring fingers push the right side of this part down the side of his left hand. As a result, part of the deck, which lies on top, must turn over face-up and face-down and fall on the part of the deck, which is at the bottom, so that the top left of the visible band shirt of the deck, which is at the bottom, a width of about about one centimeter.

The fingers of the left hand should leave the gap between the parts of the deck and allow one part of the deck to fall on another close and merge into a single deck. The boundary between the parts will be easily determined due to the upper strip of the shirt about a centimeter wide. After that, the left thumb goes under the bottom of the deck, which is closer to the palm of your hand, and causes the deck to rotate in a clockwise direction around the axis of rotation, which is located in the center of the longitudinal part of the card. The rest of the fingers, which should press on the right edge of the deck, helping it to rotate as long as the deck does not turn 180 degrees. After this, the second rotation of the thumb, the index finger of the left hand, using a strip width of about centimeters, beginning to rotate the portion pack, which is at the top, clockwise around the same axis of rotation which extends through the middle longitudinal portion cards as long as this part does not turn 180 degrees to face down.

As a result, a deck of cards will take its original position. Volt was made three rotations in 4 main steps: first was turned over the top of the deck, then the edge is formed by a shift width of one centimeter, then the whole deck was turned over and a portion of the deck, which was on top was turned using a shear edge.