How to make, amulet catcher dreams, own hands.

The dream catcher is an Indian talisman that protects the sleeper from evil spirits. Try to hang a dream catcher at the head of the bed. Ancient legends claim that the dream catcher gathers all the dreams, restraining nightmares and letting only pleasant dreams pass to the sleeping person. To make such a trap of dreams is possible with your own hands.

We will need:
* Wooden hoop (for example, inner half of the hoop) with a diameter of 15cm;
* Cord diameter of 2mm, 12m;
* Strong thick thread;
* Beads (optional);
* 3-4 pen;
* Transparent quick-drying glue;
* Scissors.

Step 1.
To fix the cord, tie it around the hoop, leaving the end length of 15cm. Take the other end of the cord and wrap it around the hoop. Make sure the cord is tight and tight. Instead of a cord, you can use braid, the amount of tape you need depends on its width.

Step 2.
So wind the entire hoop. Finish the ends tightly.

Step 3.
Close the knot from the cord firmly tie the thread.

Step 4.
After 3-4 cm after the start, make a half-knot around the hoop. That is, wrap the thread around the hoop and thread it into the formed loop. Tighten.

Step 5.
Make the same half-nodes at equal distances along the entire hoop. The distance between the end and the start should be slightly less.

Step 6.
Now, again, make a half-knot, but this time wrap the thread around the hoop, but around the very same thread stretched in step 4.

Step 7.
Repeat step 6 in a circle.

Step 8.
Thus, walking in a circle and reducing the distances between nodes, weave a spider web. The last node tie a full knot. Cut the ends of the thread close to the knot and lubricate the knot with a thin layer of glue.

Step 9.
In step 2, we left the 15-meter tail of the cord. Now cut twice the 30 cm cord and tie the pieces of cords as in the picture.

Step 10.
String the beads on the cord. Attach one end to the feather. (If you have a feather without a fastener, simply fold the end of the cord and feather near it and tightly wrap it with a thin wire or thread.) At the other end, you can string a large bead. To the beads do not slip down, tie knots.

Step 11.
Repeat the same with other lengths of the cord. At the bottom, you can tie a thread and string small beads on it.

Step 12.
Cut one more piece of cord. Thread it through the hoop from above and tie the ends. Turn the cord so that the knot is on the bottom. Fold the resulting loop in half and make the knot close to the hoop. On a loop folded in half, string a bead with a large hole. Make another knot.

Step 13.
The dream catcher is ready. Pleasant dream.