Manufacturing of crocheting.

Catching crayfish is not an easy task. It is enough to have a rakolovku (tent), which can be easily done by one's own hands . The simplest and most common construction of the rakolovki is a ring made of steel wire with a diameter of 40-50 cm and covered with a mesh. The disadvantage of such a rakolovki is that it needs to be checked every 25-40 minutes. Because the crayfish having eaten, can easily leave it.

The rakilovka, the manufacture of which is described below, can be left overnight, as 90% of the crayfish caught in this plant will be hard to get back.

To make a frame with your own hands, we will need:
- fine mesh;
- wire diameter 4-6mm .;
- plastic clamps;
- a nylon thread.

First of all we make two metal rings. The lower ring is 40-50 cm in diameter, and the upper ring is 15-20 cm in diameter.

We take the net to the ring with plastic clips every 5-7 cm. Instead of plastic clamps, you can use a nylon thread.

We make three spacers, from a wire of smaller diameter, for this purpose I used electrodes d 3mm. Spacers should be made equal in length and in such a way that the ring of smaller diameter is centered at a height of 12-18 cm.

To make the frame for easy transportation, it is possible to fold, one of the three spacers is made removable. The remaining two are fixed on the rings.

After the spacers are installed, we tighten the sidewalls of the frame. And we take the clamps on the upper ring.

Clamps on the upper ring are fixed in steps of 10-15 mm. After that, the excess cut off and the rakolovka ready for operation. Now you can safely throw a rakulovku in the water and in the morning with a calm soul to harvest

To the last, I want to note that the bait should be tied to the bottom of the rakilovki. It is best to use fresh fish, and not rotten, as many believe. Experienced rakolovy put with bait and a little dill and, in a mesh bag, a piece of cake and a slice of rye bread, whose crust is rubbed with garlic.