This page has been robot translated, sorry for typos if any. Original content here.

TECHNOLOGY OF MANUFACTURING OF CONDUCTIVE ADHESIVE GLUE

Glossary of terms

but | b | in | | g | d | ж-и | to | | l | m | n | about | n | rs | t-y | fc | ш-я

Recipe N1:

Graffiti powder (the most refined tortured) ............. 15g.
Separately powdered ................................................ .................. 30d.
Copolymer vinyl chloride-vinyl acetate .................................... 30d.
Acetone neat ................................................ ............................. 32d.

In the facade stupa carefully mix all the components. The finished glue (silky-colored liquid of gray-black color) is transferred to a glassware with a sample of a container.

Before using glue, good gloves stir with a glass rod. The viscosity of the adhesive can be reduced by adding acetone. It dries for 10-15 minutes. This recipe is used for the need for a RELIABLE connection with sufficient electrical conductivity.

Recipe N2:

Separate powder .......................................... 60g
Graffiti powder ........................................... 6 g
These substances are well mixed in mortar. The binder is added to the resulting mixture:
Nitrocellulose ................................................. .. 4 g
Acetone or ethyl acetate .............................. 30 g
Natural rosin .......................................... 2.5g

All substances are thoroughly mixed and well rastirayut until obtaining a homogeneous paste mass. Before using the glue again stir, small quantities of acetone or ethyl acetate are added, until the desired viscosity is reached.

It can be similar to use the other binder:

Shellac natural ......................................... 3g
Ethyl alcohol denatured ............. 31g

This binder is poured into a powdered mash of grain as well as graffiti.

Glue with shellac binding agent is used for gluing mechanically unloaded elements.