Navigation: =>

Home / Electronics / Circuits / Special devices ... /

Scheme of electric shock.

Electroshock

Schematic options: => 1 | 2 | 3 | 4 | 5 | 6th

Electroshocker is a device for individual self-defense from ill-wishers, by electric shock of high tension.

Electric Shock Scheme

Electric Shock Scheme

Assembling the Electroshock

The coils are wound on a ferrite magnetic circuit with a cross section of at least 0.5 cm and a permeability of 2000, for example, on a ring or on an armored magnetic circuit. The L3 coil has 600 turns of PELSHO or PEV-2 wire with a diameter of 0.2 mm. At the top of the coil L3, two layers of insulation are laid, and then the coils L1 and L2 are wound: L1 - 8 turns of the PEL wire with a diameter of 0.4 mm with a branch from the middle; L2 - 12 turns of PEL wire with a diameter of 0.8 mm.

R1 - 330 Ohm; R2 - 30 Ohm; VD1, VD2 - KD105; VT1, VT2 - KT816; C1 - 1000 uF x 400 V (to pick up with a small leak, for example type K50-73 or Japanese manufacture)

The device is mounted in a rigid case; The distance between the pins X1 and X2 is 30-40 mm, their length is 50 mm. The power is supplied by the button KN1 for a short time. Power supply - 4 series-connected elements D-0.55.

TECHNICAL DATA

  • Capacitance capacitor 100 μF (more than enough)

  • Voltage on the storage capacitor is 350 V

  • Storage of charge on the capacitor after turning off the power - at least 30 minutes.

Attention!
When working with the device, do not forget the safety rules!

Date of publication 22.03.2003.